CMD=EP
Control B
| CMD | Command 0 (EP): Erase Page - Only supported in the USER and AUX pages. 1 (EB): Erase Block - Erases the block addressed by the ADDR register, not supported in the user page 3 (WP): Write Page - Writes the contents of the page buffer to the page addressed by the ADDR register, not supported in the user page 4 (WQW): Write Quad Word - Writes a 128-bit word at the location addressed by the ADDR register. 16 (SWRST): Software Reset - Power-Cycle the NVM memory and replay the device automatic calibration procedure and resets the module configuration registers 17 (LR): Lock Region - Locks the region containing the address location in the ADDR register. 18 (UR): Unlock Region - Unlocks the region containing the address location in the ADDR register. 19 (SPRM): Sets the power reduction mode. 20 (CPRM): Clears the power reduction mode. 21 (PBC): Page Buffer Clear - Clears the page buffer. 22 (SSB): Set Security Bit 23 (BKSWRST): Bank swap and system reset, if SMEE is used also reallocate SMEE data into the opposite BANK 24 (CELCK): Chip Erase Lock - DSU.CE command is not available 25 (CEULCK): Chip Erase Unlock - DSU.CE command is available 26 (SBPDIS): Sets STATUS.BPDIS, Boot loader protection is discarded until CBPDIS is issued or next start-up sequence 27 (CBPDIS): Clears STATUS.BPDIS, Boot loader protection is not discarded 48 (ASEES0): Activate SmartEEPROM Sector 0, deactivate Sector 1 49 (ASEES1): Activate SmartEEPROM Sector 1, deactivate Sector 0 50 (SEERALOC): Starts SmartEEPROM sector reallocation algorithm 51 (SEEFLUSH): Flush SMEE data when in buffered mode 52 (LSEE): Lock access to SmartEEPROM data from any mean 53 (USEE): Unlock access to SmartEEPROM data 54 (LSEER): Lock access to the SmartEEPROM Register Address Space (above 64KB) 55 (USEER): Unlock access to the SmartEEPROM Register Address Space (above 64KB) |
| CMDEX | Command Execution 165 (KEY): Execution Key |